The Honeycomb Bravo Flap Detent System has been developed for ease of use and quick swap outs between differnet amounts of detent requirements for different Aircraft.
The main frame clips on to the side of the Bravo and there is an optional adhesive Velcro disc to help secure it, but it is not required for use if you don't want to use it. There are 2 magnets in the frame that align with the 2 magnets on each of the detent clips and they clip to the frame as well, the magnet are really there to allow for wear and tear to extend the life of the unit when swapped frequently. There is a flap lever riser with a damped spring that fits around the existing flap lever to aid acurate positioning in to each of the available positions.
The 9 detent clips have from 2 to10 detents allowing you to match the amount of flap position variations for each aircraft.
There is no need to remove the frame from the Bravo when not using the flap lever attachment, just remove the flap lever riser and the detent clip and you are good to go.
The detent clips come on a nifty stand for easy storage, there are 2 magnets on the base of the stand which align to the 2 center screws on the top of the Bravo so you can always have them to hand.
The frame is available in Black for a discreet look or white to stand out. The detent clips are availble in white only.
This kit contains:
- Bravo Frame (black or white)
- Flap Lift (white)
- 9x detent clips (2-10 detents) (white)
- detent clip stand (black)
Note: This item is made from 3D printed PLA+ and can withstand temperatures up to 50°C without deformation or softening. There will be obvious print lines on this product due to the nature of 3D printing. Please use the contact us form if you require a higher temperature material and we will endeavour to accommodate your requirements at an extra cost.
This product was added to our catalog on Friday 03 June, 2022.