This Quick Release Footplate Kit is designed to mount to the base of the MFG Crosswind Rudder Pedals to allow quick mounting to and from from your rig.
This kit contains:
- 1x QRMin MFG Adpater Plate
- 2x QRMin MFG Hook Plates (left/right)
- 4x M6x16mm s/s CSK Skt Screws
- 2x M6x22mm s/s CAP Skt Screws
- 2x M6 s/s Washers
You will need either the QRMin Base Plates x3 or the QRMin Base Plates x5 Kit to mount to your rig in order to use the QR Plates in this kit.
The second image shows the fully assembled QRMin Base Plate x3 kit and this kit in place with an illustration of the MFG Crosswind template.
Note: You may need to remove the self adhesive pads on the base of the MFG Crosswind pedals to use this kit (if they are installed).
Note: This item is made from 3D printed PLA+ and can withstand temperatures up to 50°C without deformation or softening. There will be obvious print lines on this product due to the nature of 3D printing. Please use the contact us form if you require a higher temperature material and we will endeavour to accommodate your requirements at an extra cost.
Pedal sets can be swapped in under a minute as shown in the video below!
If you have different racing pedals or different rudder pedals, then please use the contact us and we will endeavour to add a design to the catalogue to accomodate your peripherals. Any information on fixing centers/dimensions would be appreciated and any new additions that you assist with will entitle you to a discount on the first run as a thank you.
This product was added to our catalog on Saturday 11 June, 2022.